Install
Experimental firmware. Read Safety before you start, and keep the restore file the installer makes.
About 15 minutes.
You need
- An OM-5 Mark II on firmware 1.1 (Menu › Setup › Firmware). Not the OM-5, not another version.
- A fully charged battery, an SD card, a card reader, a computer with Python 3.
1. Make the card files
- Download this project: on GitHub, Code › Download ZIP, and unzip it.
- Open a terminal in the unzipped folder and run
python3 patch.py --release v0.1.0-alpha12. The double-click scripts use the newest release. - It displays an experimental firmware warning and asks you to type
UNTESTED. Then it downloads OM's official firmware 1.1 from OM's server (90 MB), checks it, adds Caduceus and checks the result against this release's checksum. If OM's server has moved on to a newer firmware, getOLY_E_148_1100_0000_0000.BINanother way, put it next topatch.pyand run again.
You get a folder card:
card/DCOLYMP/E1489999.BIN |
the update with Caduceus |
card/OM5MOD/LOOKS.BIN |
the ten starter looks |
card/restore/DCOLYMP/E1489999.BIN |
OM's own firmware, to go back. Keep it. |
Running the installer again keeps any existing card/OM5MOD/LOOKS.BIN, so your custom looks are not replaced.
It prepares the restore file before publishing the update file. If file preparation fails, fix the reported
problem and run it again before copying anything to the card.
2. Copy to the SD card
Copy the folders DCOLYMP and OM5MOD from card to the top of the SD card (not inside DCIM).
Use the card in slot 1.
3. Update the camera
- Camera off.
- Hold OK and switch the camera on. Let go of OK when the orange light is steady. The screen stays dark.
- Steady light: writing, about two minutes. Do not touch anything.
- Blinking light: done. Switch off, then on.
- Delete the
DCOLYMPfolder from the card afterwards (so it cannot be flashed again by accident). KeepOM5MOD.
The camera's firmware version still reads 1.1.
4. First use
Half-press the shutter button once after switching on. Then OK › Picture Mode: after Color Creator you find Color Profile 1–3 and Monochrome Profile 1–3. Using it.
Going back to OM's firmware
If something goes wrong
- Fast blinking at once, no steady light: the file was refused. It must be
DCOLYMP/E1489999.BINat the top of the card, made by the launcher (it checks its own result). - The camera starts normally and nothing changed: OK was not held from before switching on.
- It does not start, or freezes: go back to OM's firmware, then please report it.